CHARACTERISTICS:
Button activation of the chip: short press walk mode | ↓↑↓↑
Maximum speed: unlimited
Display: real values
Speed limit: YES
Compatible with:
Engines OLI
Not compatible with:
SpeedBox App
If you update the software of your e-bike, first uninstall the SpeedBox from the e-bike, update the software, reinstall the SpeedBox in the e-bike.
Third generation smart chip for electric bikes with OLI motors. With the SpeedBox 3.0 tuning chip, you can freely set the speed limiter of the e-bike. After installing the chip, real data such as top speed, average speed, daily distance and range will be shown on the e-bike display.
How does SpeedBox 3.0 work?
You activate the SpeedBox 3.0 chip on the e-bike display. The tuning is activated by a short press of the Mode-Walk. The display briefly shows 9.9 km/h (6.2 mph) and from now on you can drive at unlimited speed. Voting is disabled by pressing the mode walk for a short time. The display shows 2.5 km/h (1.6 mph) and the speed limit of 25 km/h (25 mph) is switched on again. The pedelec then works as it did before the chip was installed.
Another way to activate the chip is the key combination ↓ ↑ ↓ ↑ and the SpeedBox will be activated. The SpeedBox can then be deactivated in the same way.
Set the maximum assist speed by switching the modes three levels down and then three levels up. The indicated speed of 1.5 km/h corresponds to a maximum speed of 15 km/h, 2.0 corresponds to a maximum speed of 20 km/h, 2.5 corresponds to a maximum speed of 25 km/h, 3.0 corresponds to a maximum speed of 30 km/h. To change the maximum speed, briefly press the WALK button or rotate the rear wheel 360°. The last displayed limit is saved after five seconds of inactivity.
Assembly
To connect the SpeedBox chip to an e-bike we use colored connectors equipped with a key for correct connection, so installing the chip is really easy. We have written detailed instructions and made videos that any customer can use to install the SpeedBox. Removing the tuning chip is as easy as installing it. If you have some connection problems, please don't hesitate to contact us.
If you want to install a SpeedBox on a brand new bike, you need to ride that bike at least 1km before you start the chip for the first time.
Download instructions
warning
Please note that operating pedelecs modified in this way on the road may conflict with the laws in force in some countries. The manufacturer assumes no responsibility for damage resulting from the use of SpeedBox products. E-bikes equipped with SpeedBox products may not be used on roads, cycle paths and public areas. E-bikes equipped with SpeedBox products may only be used at your own risk and under your own ownership. Using SpeedBox products may void your e-bike warranty.
We recommend the use of additional safety features and protective products to avoid injury.