Free shipping from 70€ within Germany & 150€ worldwide. Tuning for private property only. Products are not covered by § 22a StVZO.

E-Scooter tuning chip for Ninebot G30D, G30, G30LD & G30D II (new version)

€67,49
Tax included. Shipping calculated at checkout.
by tuning-chips.com
In stock

This tuning chip removes the speed limit of the e-scooter so that it drives between 28 km/h and 33 km/h. Installation is very easy and only takes 5 minutes.

The chip was developed exclusively for the Ninebot models of the G series (G30D, G30, G30LD & G30D II (2nd generation)). Before purchasing, please check the software version of the scooter. This must not be higher than v1.7.0. be - v1.7.13. and higher/newer no longer works!

After connecting the tuning chip, the e-scooter can be used normally and initially only drives at its "legal" 20 km/h. The tuning only becomes active after 8x clicks on the power button. Depending on the load (driver's weight), the e-scooter then reaches a speed of between 28-33 km/h. If you switch off the e-scooter, the tuning is deactivated - the next time you drive, you have to press the on button 8 times again. In this way, you can easily control when the e-scooter's throttling is active and when it is lifted.


The original speedometer shows the higher speeds correctly.
  • Easy installation: The enclosed instructions explain the installation step by step. The installation is very easy and done in 5 minutes.
  • Easy to use: After the simple installation, the speed limit can be easily canceled before each journey by pressing the button on the speedometer 8 times. After switching off, the e-scooter drives again at 20 km/h until the tuning is activated again.
  • Simply inconspicuous: You can remove the tuning chip just as quickly and easily as you installed it. The chip is not visible from the outside because it is hidden in the handlebar.