for the normal Brose sensor you need it badassBox 4 Brose.
The badassBox 4 Brose CS set includes all the parts you need to mount the badassBox 4 on your e-bike with a Brose mid-mounted motor and pen-shaped CS sensor:
With the badassBox 4 Brose CS set, you not only have all the parts you need to tune your bike with one click, you also save money at the same time.
installation
The pin-shaped CS sensor is located in the dropout area.
To get to the sensor you have to remove the rear wheel.
Loosen the screws on the bracket that attaches the sensor to the dropout.
Separate the sensor from the bracket.
Slide the pen-shaped sensor into the adapter so that the flat side of the sensor aligns with the corresponding recess in the adapter. The sensor must be pushed fully into the adapter so that only the cable is protruding and the snap lock is flush with the surface of the adapter. (In the photo, the sensor is not fully inserted.)
Fasten the adapter to the frame of your bike with the supplied cable ties.
Reinstall the rear wheel of your bike.
Slide the badassBox onto the adapter until it clicks into place.
Mount the spoke magnet and align it with the edge of the badassBox housing. That's it. Have fun with your faster e-bike!
